Login/Opret dig Din kurv
 

Produktet er tilføjet til din kurv.

Total produkter (eksl. moms)
Levering (eksl. moms) Gratis!
I alt (eksl. moms)
Forsæt indkøb Forsæt til betaling
Forside > Skole>Programmering>Arduino>Shields>SparkFun USB Host Shield

SparkFun USB Host Shield

DEV-09947


Varen er på fjernlager

Forventet leveringstid 1-2 uger

DEV-09947

This new version corrects the pin out for the GPX and RESET pins. The SparkFun USB Host Shield contains all of the digital logic and analog circuitry necessary to implement a full-speed USB peripheral/host controller with your Arduino. This means you could use your Arduino to interface with and control any USB slave device - thumbdrives, digital cameras, bluetooth dongles, and much more!

Pris DKK 210,00
inkl. moms
DKK 262,50

Før

Færre mere

This new version corrects the pin out for the GPX and RESET pins. The SparkFun USB Host Shield contains all of the digital logic and analog circuitry necessary to implement a full-speed USB peripheral/host controller with your Arduino. This means you could use your Arduino to interface with and control any USB slave device - thumbdrives, digital cameras, bluetooth dongles, and much more!

A four-wire serial interface is used to communicate with the host controller chip, so the shield connects the Arduino’s hardware SPI pins (D10-13) to the MAX3421E. A USB type A female connector is wired up to the IC, and it also supplies 5V as any normal USB port would.

The Host Shield takes its power from the ‘Vin’ pin on your Arduino. Power from that pin is regulated to both 5V and 3.3V on the shield. All SPI signals are sent through a hex converter to step them down to 3.3V.

Documents: